This can be easily done by winding around 10 - 15 turns of coax on a 4" former, fastening with plastic wraps or tape and then removing the former so that the coil is air wound. I was viewing just viewing each band at a time, not the whole spectrum, which will obviously look like sharp SWR notches. The wire can be insulated or bare. See questions and answers. Image Unavailable Image not available for Color: Our price is lower than the manufacturer's "minimum advertised price.
What I found was that the tuning of the segments and traps was now much more critical, since the acceptable SWR range was now much narrower. The VSWR on all bands was less than 1: It was a pleasant surprise to hear great reports back on 40 meters. I used the manufacturer's instructions for the dimensions, but I followed the recommendations in the DX Engineering manual in other respects. I just build to specs, then use trap tuning.
Install coax feedline and radials if needed as shown in figure 7. See and discover other items: Includes solder lugs on one end for easy connection to ground post. You can bend the radials, leave out some areas, just as the surroundings allow. My comment would be to monitor the receive signal to noise ratio while adding radials.
Have one to sell? Well, folks, that changed things considerably. I had it tied to a fence post and my radials were abt ft of chicken wire attached to the split rail fence. The popular way to mount a vertical antenna is at ground level. In Stock Estimated Ship Date: Only 1 left Quantity: